For work, you will need corrugated board, square tube 40 * 60, square tube 100 * 100, cement and sand.
First you need to boil a frame for a gate of a square pipe 40 * 60. A square tube is taken and pieces are cut off at the desired gate width and height.
The pipes are welded into a square and in the middle of the square one more or two pipes are welded, depending on what height the pipes will be. It will be the frame of one half of the gate. The second half is welded similarly. After that, corrugated board is attached to the welded frame, this is done with the help of screws for metal with drill and milk. Next, the square tube 100 * 100 is measured in this way, the height of the gate plus the gap between the gates and earth and plus the segment of the segment in the ground (about 1 meter). After installing the gate, you should take up the interior of the house, installing the attic stairs you can be sure that there will be comfort and beauty in the house.
You will need two such pipes, as it will be racks for the gate. Sales are welded to the racks, and on the frame for the gate of the hinge loop. After that, pits for racks are dug up, 1 meter deep. Racks are inserted into the pits and the gate frame is put on them. Further, the gates are exposed in terms of horizontal level and in two planes vertically and are reinforced by temporary spacers. The exposed racks are poured with concrete after which the bolt is attached from the inside of the gate and the gates are ready.