Any floor covering should have a strong and even base under it. There are special machines from China using these machines you can easily make a bulk floor. And also to make such a coating is quite possible and with your own hands. Consider in stages the procedure for filling the finish -free floor.
Preparation of the base
One of the important stages in the preparation of the base for the moisture is a damping tape. It must be laid or glued along the perimeter of this room. Now arising linear extensions, in the places where the screed and walls are adjacent, compensates for the tape.
Clean the surface of dust and dirt with a brush. We shed the foundation of a deep penetration primer. This will enhance the clutch of the base and the filled material. The soil should dry for 30-60 minutes.
Installation of the beacons
When working with a large room, uniformly applying the mixture is quite problematic, in such cases, lighthouses are installed. With their help, the area is divided into areas. For a small layer of screed, I use metal beacons. For a layer of 2 to 10 cm, a metal profile (tubes, corners) is used). They must be fixed with a solution. Lighthouses are pressed into the solution and aligned with the level. The voids are filled with a spatula under the beacon. This is done to form the boundaries of the sites, so the solution will not spread over the entire surface of the room.
The driving time of the beacons depends on the solution used and the thickness of the layer.
Pouring the bulk weeping the solution. The required amount of water is first poured into the container, and only then a dry mixture is poured out. It is important to always observe the proportions indicated on the dry mixture.
The induced portion of the solution is poured to the floor and rolled with a special roller (aeration needle), thereby the solution is distributed along the plane and the air that came into it is expelled.
We pour to uniform filling of the entire area. If lighthouses were used in the process, then such areas are filled with alternating with empty ones – according to the application technology.