Modern decoration of entrance home doors is full of a wide variety of design. In practice, the front door is often sheathed with insulating material from the outside. But the mass passion for installing metal doors, for better protection of their home from encroachments of ill -wishers, is slightly complicated by the performance of this work. In this case, it is more expedient and better if the upholstery of the doors is made from the inside of the apartment.
And the very need for the upholstery of the metal door is due to the fact that, despite the high -quality insulating material of the door frame, the cold from the landing or from the non -heated canopies of the private house, it is transmitted through the metal frame to the inside. And wet indoor air forms condensate on the surface of the metal.
For a long period, the upholstery of the doors from the outside is performed by dermatin. Thanks to easy cleaning and washing, affordable price and quality, this material has not lost its popularity and currently. Dermatin is produced in different shades and can satisfy any consumer.
For high -quality doors sheathing, it is recommended to use domestic material. It is not inferior in quality to imported, but much less cost. The width of dermatin usually corresponds to the sizes of the door. The amount of material is calculated depending on the size of the sheathed door, with the necessary vehicle in the amount of 12-15 cm along the entire perimeter of the door.
For high -quality heat and sound insulation, doors upholstery are performed using a lining of foam or insolon. Nutrition of the finishing material to the wooden door is performed with special nails with a wide, curly hat. Previously, the insulation material is attached to the door with a stapler or glue. The final nail nail is carried out according to the previously applied scheme. This, firstly, ensures a tight fit of the skin on the door surface, and secondly, the figure design of the skin (rhombus, rectangle or circles) is achieved.
The procedure for performing work may be as follows:
Remove the door from the loops and disconnect all the accessories,
Strengthen insulation material,
Cut the protruding edges of the insulation on the metal door around the perimeter, and on a wooden with a drop of 10-12 cm,
On a wooden door, the protruding edges of the dermatin are stuck under a layer of insulation, forming a roller, and are nailed around the entire perimeter with a step of 6-8 cm,
On the metal door, the edges of dermatin are glued to the side ends of the door and on the insulation.
And at the end of the work, it is necessary to wrap the handle and locks in its place, as well as install the door on the loops.